Working Principle

Diaphragm valves feature is the original seal system, allowing the valve and diaphragm to provide a distinct sealing edge. This measure reduces the ring-shaped gap between diaphragm and valve body in the external sealing area. This special feature makes in diaphragm valves suitable for sterile applications.

Application

CSE manufactures a full offering of diaphragm valves for hygienic and high purity applications in industries like Pharmaceutical, Food, Beverage, Cosmetic, and Fine chemical process Industries. CSE diaphragm valves offering multiple valve functions while maintaining aseptic and sterile sealed conditions. The valves can be configured to provide integral sampling and multi-port functions, to minimize deadleg, and to enable full trainability. The sterilizable and autoclavable design of valves also provides for operational efficiency in cleaning cycles.

Actuator Control mode

According to the site condition has the following three kinds of control mode, the reasonable selection of the control method can make your valves service life more longer, more convenient operation, cost savings.

1.Normally open type user

Suitable for pneumatic valve in the working time longer occasion. When the valve is normally open spring does not load external gas source thrust, then the valve fatigue to a minimum. Because it is by the air pressure to close valve, so need filed air pressure stability, air supply reliable.

2.Normally closed type user

Suitable for pneumatic valve is in the closed time working longer occasion. For depends on the spring to close, when air pressure to drive the piston push spring, valve open. So for the normally closed user this valve service life more long, gas more economical. At the same time when the air supply fails, the valve is in the closed state, this control state is the most widely used.

3.Double acting type user

Double acting type refers to the two chambers can be input compressed air separately, realize the two-way movement of the cylinder, no spring in the cylinder, the valve opening and closing rapidly, and can be used for large stroke valve, because it is by air pressure to close valve, so need the field gas source stability, air supply reliable.

Details

Size:1/2",3/4",1",1.5",2"
MOC: SS316L
Operation: Normal Open / Normal Close
Connection Type: Clamp End / Weld End
Working temp: Assembling Diaphragm?EPDM(-40 C ~150 C0?PTFE/EPDM(-10 C~150 C)
Working pressure:Max. 10 Bar
Surface : SF1 - ID Polished to Ra <= 0.5µm- 320 Grit
SF4-EP Finished to Ra <= 0.38µm- 420 Grit
ID/OD Mirror Polished & ID Ra <= 0.8µm/OD -180 Grit

Specifications